Skip to content

Bill of Materials

Jump to bottom
Hugh Elliott edited this page Dec 31, 2021 · 3 revisions

Hardware not included in this repo to connect to the PCB is as follows

  • 1/2in x 4-ft length of aluminum C-channel (typically used as plywood edging) - Canadian Tire
  • 3 x M5 12mm screws - McMaster-Carr
  • 4 x M3 10mm screws - McMaster-Carr
  • 4 x M3 Heat-set inserts - MacMaster-Carr
  • USB cable with A type end to plug into standard battery pack
  • 2 x 2.54 male 2-pin JST connectors Amazon.ca, Amazon.com
  • 1 x female 3-pin JST SMP connector Amazon.ca, Amazon.com
  • tactile switch whatever temporary on-off switch you want. For the switch assembly in the STLs, a 12x12mm tactile switch, 5-10mm plunger
Clone this wiki locally