Skip to content

Latest commit

 

History

History
57 lines (36 loc) · 2.97 KB

README.md

File metadata and controls

57 lines (36 loc) · 2.97 KB
Raw

Table of Contents

Introduction

This repo contains Terraform templates to help deployment of OpenShift Container Platform (OCP) 4.x on PowerVM LPARs. This assumes PowerVC is used as the IaaS layer for managing the PowerVM LPARs.

If you are using standalone PowerVM please take a look at the following quickstart guide which uses the ansible playbook to setup helper node (bastion) for OCP deployment.

This project also leverages the same ansible playbook internally for OCP deployment on PowerVM LPARs managed via PowerVC.

Run this code from either Mac or Linux (Intel) system.

❗ This automation is intended for test/development purposes only and there is no formal support. For bugs/enhancement requests etc. please open a GitHub issue

Pre-requisites

You need to identify a remote client machine for running the automation. This could be your laptop or a VM. Install the below required packages on the client machine.

  • Git: Please refer to the link for instructions on installing the latest Git.
  • Terraform: Please refer to the link for instructions on installing Terraform. You'll need to use version 0.12.20 or later. For validating the version run terraform version command after install.
  • Public internet connection for all the nodes to download the playbooks and images as part of the setup process.

Image and LPAR requirements

You'll need to create RedHat CoreOS (RHCOS) and RHEL 8.0 (or later) image in PowerVC. For RHCOS image creation, follow the steps mentioned in the following doc.

Following are the recommended LPAR configs for OpenShift nodes that will be deployed with RHCOS image.

  • Bootstrap, Master - 2 vCPUs, 16GB RAM, 120 GB Disk.

    PowerVM LPARs by default uses SMT=8. So with 2vCPUs, the number of logical CPUs as seen by the Operating System will be 16 (2 vCPUs x 8 SMT)

    This config is suitable for majority of the scenarios

  • Worker - 2 vCPUs, 16GB RAM, 120 GB Disk

    Increase worker vCPUs, RAM and Disk based on application requirements

Following is the recommended LPAR config for the helper node that will be deployed with RHEL 8.0 (or later) image.

  • Helper node (bastion) - 2vCPUs, 16GB RAM, 200 GB Disk

OCP Install

Follow these quickstart steps to kickstart OCP installation on PowerVM LPARs managed via PowerVC

Contributing

Please see the contributing doc for more details. PRs are most welcome !!