Does TJC_SET

[vw72]

The December Rev 1 firmware states that DWIN_SET needs to be updated. Does this apply to the TJC version, too? If so, where might the update be located? The last I can find is from May 2023.

[classicrocker883]

sorry for late reply I hope you found the answer, but the TJC set doesn't use the same DWIN_SET. I'm not exactly sure when the last update was, but check out the
display assets.

see if the files match the files you used to upload (compare by byte size or whatever).

[vw72]

The TJC_UPDATE.ZIP in the directory is the 5/2023 version which I already have installed. BTW as of the December release, no matter what I do, I can't get previews to show. Doesn't matter whether using Cura, Prusaslicer or Orca. Joe

…

On Sun, Jan 7, 2024 at 6:05 PM Andrew ***@***.***> wrote: sorry for late reply I hope you found the answer, but the TJC set doesn't use the same DWIN_SET. I'm not exactly sure when the last update was, but check out the display assets <https://github.com/classicrocker883/MRiscoCProUI/tree/HEAD/display%20assets> . see if the files match the files you used to upload (compare by byte size or whatever). — Reply to this email directly, view it on GitHub <#94 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BAKGTRALDLO3AIYY63J6VPTYNMZ3DAVCNFSM6AAAAABBBHJPICVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DANBSGMYTI> . You are receiving this because you authored the thread.Message ID: ***@***.*** .com>

[classicrocker883]

You will need to update the slicer scripts .py files, just copy and paste into their directories.