Is there a Voxelab Aquila N32 mainboard specific release for BLT?

[doctorevil30564]

Just got a Voxelab Aquila S2 with a N32 mainboard. I had hoped that the firmware would be better than the original firmware that came on my other Voxelab Aquila that I replaced with Alex's firmware before he stopped working on it.

I figure the direct drive on the S2 needs to have different e-steps compared to the X2 or the original Aquila.

Thanks for responding in advance.

[classicrocker883]

theres a BLT version for N32. I do recommend using the UBL instead. but you can change the e-steps to whatever suites the printer, either through the LCD screen menu or using a terminal and entering the Gcode commands.

[NTPanaccio]

I have tried the latest 3 builds of "Aquila_N32_BLT-ProUI" on my X2 with a BLTouch, and each time have had the same issues:

• I preheat the hot end and bed, hit Auto home, and it will report a bed temperature error upon the first hit of the BLT probe (LCD actually shows a negative number when it does this), and it tells me to shut off the printer (MINTEMP error)
• I preheat the hot end and bed, then try and create a mesh, and same as above, first hit with the probe and it gets a low bed temp warning, but doesn't tell me to shut down the printer

I installed Alex's last firmware (BLTouch-3x3-N32.bin) and don't have any of these issues. Any ideas here?

[classicrocker883]

there are some differences with -BLT version that may have issues I may not be able to solve, I recommend using the -UBL version instead. I will have to go through some testing inorder to recreate and tackle that issue, for now try -UBL, or try the most recent updated -BLT version which has been posted in releases.