HyperSerial
Advanced configuration & diagnostic for ESP & Raspberry Pi Pico board with uploaded HyperSerialEsp8266, HyperSerialESP32 or HyperSerialPico firmware.
HyperSerialPico requires HyperHDR v20 or newer.
Find out more here:
- https://github.com/awawa-dev/HyperSerialESP32
- https://github.com/awawa-dev/HyperSerialEsp8266
- https://github.com/awawa-dev/HyperSerialPico
Esp8266/ESP32/rp2040 handshake option:
that allows:
-
reset the ESP32/Esp8266 board at the beginning
-
after the reset is performed, we read the initial HyperSerialEsp8266/HyperSerialESP32 boot message and check it
-
if the board is not capable of the 2Mb speed (or any other speed set in HyperHDR) the user will see a warning
-
after the LED device is stopper, we read the statistics (just wait few seconds). Still we maintain one way communication at the same time, because of problems with the performance of duplex for certain system/drivers.
Also please check out other new feature added in the previous commit, that shows how many frames were dropped due to slow LED device or too high refresh rate set in the smoothing:
