Putting my Solder where my Mouth Is #765
mosqu-ito
started this conversation in
Show and tell
Replies: 3 comments 4 replies
-
Don't put solder where your mouth is unless it's lead-free |
Beta Was this translation helpful? Give feedback.
0 replies
-
Whenever I feel like I need a third hand, which is often, I rip off a foot of good old 60/40 and shove it right in there. When I was little, my dad gave me half a pound of mercury for toy. |
Beta Was this translation helpful? Give feedback.
1 reply
-
I always suspected it had been sold by the full pound. I'll bet he kept half of my mercury to play with himself. He's lucky he's dead. |
Beta Was this translation helpful? Give feedback.
3 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Recently I launched into a great spiel about using CCL for switch debouncing
and for frequency divide-by-two with 50/50 duty cycle. I did this despite having
learned almost everything I know just this week. :D
(Yes, I can be one of those.)
Anyway, it doesn't take long to put a switch and a couple of LEDs on a perf board.
So I did. And, now I have an all-hardware debouncer and divider. Unlike my last
little perf board, this demo is a sequential circuit (kinda the whole point).
And because it's sequential, to prove it works as advertised would require a short
video. I'm not sure if I'm supposed to do that, even assuming I could produce such
a thing and figure out how to upload it. So for now, I'm just going to give you a
still and ask you to trust me.
And here's one of my little boxes...
I like to annotate where the information appeared in the datasheet. (scroll far right)
Please don't trash the way I write to registers. I'm old. You'll hurt my feelings. And then I'll die.
Beta Was this translation helpful? Give feedback.
All reactions